Glove Box Regeneration Ways

From The Third Age: Wiki
Jump to: navigation, search

1) Regeneration fuel: a mixture of hydrogen and inert fuel (hydrogen accounts for five% -10%)

2) Quantity: 40L fuel cylinder 10Mpa

three) Regenerative gasoline strain: .05Mpa (the gasoline use for every fifty percent hour in the condition of .05Mpa is that the cylinder tension drops by 1.5Mpa. If it exceeds 1.5Mpa, the strain of the strain regulator’s program will be diminished, if it is significantly less than 1.5Mpa Raise the pressure of the strain regulator plan)

4) System: 3 hours heating-3 several hours heating and ventilation-3 hours vacuuming-one hour pumping-ten several hours cooling

five) Measures:

① Hook up the regeneration gas (look at the pipeline for leaks following connection: vac glove box following connecting, open the most important valve of the stress lessening valve to the highest, open up the auxiliary meter to .1Mpa, switch off the key valve, hold out 15 minutes, if the force of the auxiliary meter remains at .1 Mpa continues to be unchanged, indicating no air leakage

>②Set the strain of the auxiliary gauge of the pressure lowering valve to .1Mpa (the pressure in the course of ventilation is about .06-.08MPa

>③ Near the cycle and analyz

r>④Turn on the vacuum pu

r>⑤ Commence regenerat

br>⑥ The new application ends at 20h (clear before cleaning, drinking water and oxygen index <200p


6) Note: Do not cut off the power and gas during the regeneration process (especially the first 6 hours)! Some pressure reducing valves are not allowed, and the pressure needs to be adjusted appropriately to ensure continuous ventilation for 3 ho


7) Observation: whether the regeneration gas flowmeter shows about 20L / min, otherwise adjust the pressure of the pressure reducing valve.